Skip to content
1900

Endoscopic Visualization of Backfire Behavior in a Medium Speed Maritime Hydrogen Engine

Abstract

Hydrogen is a promising energy carrier for decarbonizing maritime and stationary applications. However, using 100% hydrogen in large-bore engines introduces combustion challenges such as pre-ignition and backfire. These statistically occurring combustion anomalies, particularly their spatial and temporal behavior, cannot be fully understood through thermodynamic data alone. This study applies optical diagnostics to a medium-speed single-cylinder research engine (bore: 350 mm, stroke: 440 mm, displacement: 42.3 dm3 ), operated with 100% hydrogen exceeding 20 bar IMEP. By varying the air–fuel equivalence ratio between 2.3 and 4.0, and comparing active pre-chamber and open combustion chamber ignition systems, backfire-induced operating limits are identified. High-speed flame imaging through two endoscopic accesses and up to three cameras captures both visible and UV (308 nm) flame chemiluminescence. An implemented visual vibration compensation method using fiber optics enables tracking of flame origins and propagation. The recordings show that 65% of ignition events initiate near one intake valve, suggesting local hydrogen enrichment, confirmed via 3D-CFD simulations. This is linked to intake manifold geometry, which leads to mixture inhomogeneity up to −260◦ CA BTDC. At loads above 15 bar IMEP, the localized enrichment reduces or shifts, attributed to increased turbulence and intake mass flow. CFD simulations also reveal that gas temperatures under the intake valves, exceeding the ignition temperature of hydrogen, as early as 300◦ CA BTDC, create the risk of backfire in the early gas phase. Additionally, glowing oil droplets and ignition zones near the piston were observed, indicating that lube oil ignition may be a cause of later (after −290◦ CA BTDC) backfire events. These findings contribute to the understanding of hydrogen combustion anomalies and support future experimental and modeling-based optimization of large-bore hydrogen engines.

Funding source: This work was part of the ‘‘Hydrogen Powered Large Engine (HydroPoLEn)’’ project, FKZ 03SX570B, funded by the Federal Ministry of Economics and Climate Protection of the Federal Republic of Germany conducted with Everllence, WTZ Roßlau, Tenneco, Carnival Corporation & PLC, and the Institute of Sustainable Mobile Powertrains at the Technical University of Munich.
Related subjects: Applications & Pathways
Countries: Germany
Loading

Article metrics loading...

/content/journal7615
2025-08-27
2025-12-05
/content/journal7615
Loading
This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error
Please enter a valid_number test