Production & Supply Chain

Water electrolysis is a promising approach to hydrogen production from renewable energy sources. Alkaline water electrolyzers allow using non-noble and low-cost materials. An analysis of common assumptions and experimental conditions (low concentrations low temperature low current densities and short-term experiments) found in the literature is reported. The steps to estimate the reaction overpotentials for hydrogen and oxygen reactions are reported and discussed. The results of some of the most investigated electrocatalysts namely from the iron group elements (iron nickel and cobalt) and chromium are reported. Past findings and recent progress in the development of efficient anode and cathode materials appropriate for large-scale water electrolysis are presented. The experimental work is done involving the direct-current electrolysis of highly concentrated potassium hydroxide solutions at temperatures between 30 and 100 ◦C which are closer to industrial applications than what is usually found in literature. Stable cell components and a good performance was achieved using Raney nickel as a cathode and stainless steel 316L as an anode by means of a monopolar cell at 75 ◦C which ran for one month at 300 mA cm−2 . Finally the proposed catalysts showed a total kinetic overpotential of about 550 mV at 75 ◦C and 1 A cm−2.

Energy supplies that are safe environmentally friendly dependable and cost-effective are important for society's long-term growth and improved living standards though political social and economic barriers may inhibit their availability. Constantly increasing energy demand is induced by substantial population growth and economic development putting an increasing strain on fossil fuel management and sustainability which account for a major portion of this rising energy demand and moreover creates difficulties because of greenhouse gas emissions growth and the depletion of resources. Such impediments necessitate a global shift away from traditional energy sources and toward renewables. Aside from its traditional role is viewed as a promising energy vector and is gaining international attention as a promising fuel path as it provides numerous benefits in use case scenarios and unlike other synthesized carbon-based fuels could be carbon-free or perhaps even negative on a life-cycle criterion. Hydrogen ( ) is one of the most significant chemical substances on earth and can be obtained as molecular dihydrogen through various techniques from both non-renewable and renewable sources. The drive of this paper is to deliver a technological overview of hydrogen production methods. The major challenges development and research priorities and potential prospects for production was discussed.

This study proposes a novel hybrid solar-gas power and hydrogen-production system which is comprised by the solar tower thermal system gas-steam turbine combined cycle and organic Rankine cycle-based hydrogen-production system. Based on the Ebsilon code the operation processes of the hybrid system are simulated. The results show that the output power and electric efficiency of the hybrid system are 103.9 MW and 41.3% and the daily hydrogen output is 62.2 kg. The operation simulation results of the hybrid system reveal that the gas-steam combined cycle and solar island can both achieve stable operations and the power generation section and hydrogen-production device can both work effectively which means the hybrid system is technically feasible. The exergy estimate results of the hybrid system show that the combustion chamber and solar receiver have the two largest exergy destructions which are 56.5 MW and 45.3 MW. That means the performances of the two components can be further improved. For the hydrogen-production system the exergy destructions of the proton exchange membrane electrolyzer turbine condenser and evaporator of the organic Rankine cycle are 0.156 MW 0.111 MW 2.338 MW and 1.891 MW and the corresponding exergy efficiencies are 51.2% 92.6% 80.7% and 79.5% respectively.

A potential method of storing and transporting hydrogen safely in a cost-effective and practical way involves the utilization of molecules that contain hydrogen in their structure such as ammonia. Because of its high hydrogen content and carbon-free molecular structure as well as the maturity of related technology (easy liquefaction) ammonia has gained attention as a “hydrogen carrier” for the generation of energy. Unfortunately hydrogen production from ammonia requires an efficient catalyst to achieve high conversion at low reaction temperatures. Recently very attractive results have been obtained with low-surface-area materials. This review paper is focused on summarizing and comparing recent advances in novel economic and active catalysts for this reaction paying particular attention to materials with low surface area such as silicon carbide (SiC) and perovskites (ABO3 structure). The effects of the supports the active phase and the addition of promoters in such low-porosity materials have been analyzed in detail. Advances in adequate catalytic systems (including support and active metal) benefit the perspective of ammonia as a hydrogen carrier for the decarbonization of the energy sector and accelerate the “hydrogen economy”.

Waste heat recovery was considered as a promising candidate for energy conservation and emission reduction. Methanol steam reforming was considered to be an effective means for hydrogen production because of its advantages. In this work a micro reactor was constructed and thermoelectric generation coupled with hydrogen production from methanol steam reforming was innovatively used to recycle waste heat which was simulated by hot air from a hot air gun. The waste heat was converted into electricity and hydrogen at the same time. The characteristic of thermoelectric generation coupled with methanol steam reforming was investigated. It was experimentally verified that both the hydrogen production rate and methanol conversion increased with the increasing inlet temperature but thermal efficiency increased firstly and then decreased with the increasing temperature. The methanol steam reforming could effectively maintain cold side temperature distribution of thermoelectric generation. In the case of the thermoelectric module (1) the highest temperature difference of 37 ◦C was determined and the maximum open circuit voltage of 2 V was observed. The highest methanol conversion of 64.26% was achieved at a space velocity of 0.98 h−1 when the temperature was 543 K comprehensively considering the CO content and thermal efficiency.

Our gas network is one of the best developed in the world providing safe secure affordable energy to homes and businesses across the UK.<br/><br/>To meet the biggest energy challenge of our generation – making deep cuts to carbon emissions by 2050 – it needs to embrace new technology which builds on these strengths and delivers the integrated flexible network of the future. This briefing sets out how it is already doing that. Take a look at our Gas Futures Messages booklet attached.

The hydrogen economy is currently experiencing a surge in attention partly due to the possibility of absorbing variable renewable energy (VRE) production peaks through electrolysis. A fundamental challenge with this approach is low utilization rates of various parts of the integrated electricity-hydrogen system. To assess the importance of capacity utilization this paper introduces a novel stylized numerical energy system model incorporating the major elements of electricity and hydrogen generation transmission and storage including both “green” hydrogen from electrolysis and “blue” hydrogen from natural gas reforming with CO₂ capture and storage (CCS). Concurrent optimization of all major system elements revealed that balancing VRE with electrolysis involves substantial additional costs beyond reduced electrolyzer capacity factors. Depending on the location of electrolyzers greater capital expenditures are also required for hydrogen pipelines and storage infrastructure (to handle intermittent hydrogen production) or electricity transmission networks (to transmit VRE peaks to electrolyzers). Blue hydrogen scenarios face similar constraints. High VRE shares impose low utilization rates of CO₂ capture transport and storage infrastructure for conventional CCS and of hydrogen transmission and storage infrastructure for a novel process (gas switching reforming) that enables flexible power and hydrogen production. In conclusion all major system elements must be considered to accurately reflect the costs of using hydrogen to integrate higher VRE shares.

There is significant interest in Australia both federally and at the state level to develop a hydrogen production industry. Australia’s Chief Scientist Alan Finkel recently prepared a briefing paper for the COAG Energy Council outlining a road map for hydrogen. It identifies hydrogen has the potential to be a significant source of export revenue for Australia in future years assist with decarbonising Australia’s economy and could establish Australia as a leader in low emission fuel production.

As part of the ongoing investigations into the hydrogen production potential of Australia Geoscience Australia has been commissioned by the Department of Industry Innovation and Science to develop heat maps that show areas with high potential for future hydrogen production. The study is technology agnostic in that it considers hydrogen production via electrolysis using renewable energy sources and also fossil fuel hydrogen coupled with carbon capture and storage (CCS). The heat maps presented in this work are synthesized from the key individual national-scale datasets that are relevant for hydrogen production. In the case of hydrogen from electrolysis renewable energy potential and the availability of water are the most important factors with various infrastructural considerations playing a secondary role. In the case of fossil fuel hydrogen proximity to gas and coal resources water and availability of carbon storage sites are the important parameters that control the heat maps. In this report we present 5 different heat map scenarios reflecting different assumptions in the geospatial analysis and also reflecting to some degree the different projected timeframes for hydrogen production. The first three scenarios pertain to renewable energy and hydrogen There is significant interest in Australia both federally and at the state level to develop a hydrogen production industry. In August 2018 Australia’s Chief Scientist Dr Alan Finkel prepared a briefing paper for the COAG Energy Council outlining a road map for hydrogen. It identifies hydrogen has the potential to be a significant source of export revenue for Australia in future years assist with decarbonising Australia’s economy and could establish Australia as a leader in low emission fuel production.

As part of ongoing investigations into the hydrogen production potential of Australia Geoscience Australia has been engaged by the Department of Industry Innovation and Science to develop maps that show areas with high potential for future hydrogen production. The study is technology agnostic but considers only low carbon production processes. It includes hydrogen production via electrolysis using renewable energy sources (referred to as renewable hydrogen) as well as fossil fuel-derived hydrogen coupled with carbon capture and storage (CCS) (referred to as CCS hydrogen). The maps presented in this work are synthesized from the key individual national-scale datasets that are relevant for hydrogen production. In the case of hydrogen from electrolysis renewable energy potential (from wind solar and hydro resources) and the availability of water are the most important factors while various infrastructure considerations also play a role. In the case of CCS hydrogen proximity to gas and coal resources water and availability of carbon storage sites are the important parameters that control the spatial distribution of potential hydrogen production. In this report we present five different scenarios that reflect key differences in technologies for hydrogen production and the requirements of those technologies. Using geospatial analysis each scenario is translated into a heat map that shows regional trends in potential for hydrogen production based on access to underpinning resources and existing infrastructure.

Three scenarios explore the future potential for renewable hydrogen produced by electrolysis. These demonstrate a high potential for hydrogen production in the future near many Australian coastal areas which is even larger if infrastructure is available to transport renewable power generated from inland areas to the coast. Results also show significant future potential for hydrogen production in inland areas where water is available. The final two scenarios focus on the future potential for CCS hydrogen: a 2030 scenario and a 2050 scenario. A key factor in future CCS hydrogen potential is related to the timeframes for the availability of geological storage resources for CO_2.

Exposing and stabilizing undercoordinated platinum (Pt) sites and therefore optimizing their adsorption to reactive intermediates offers a desirable strategy to develop highly efficient Pt-based electrocatalysts. However preparation of atomically controllable Pt-based model catalysts to understand the correlation between electronic structure adsorption energy and catalytic properties of atomic Pt sites is still challenging. Herein we report the atomically thin two-dimensional PtTe₂ nanosheets with well-dispersed single atomic Te vacancies (Te-SAVs) and atomically well-defined undercoordinated Pt sites as a model electrocatalyst. A controlled thermal treatment drives the migration of the Te-SAVs to form thermodynamically stabilized ordered Te-SAV clusters which decreases both the density of states of undercoordinated Pt sites around the Fermi level and the interacting orbital volume of Pt sites. As a result the binding strength of atomically defined Pt active sites to H intermediates is effectively reduced which renders PtTe₂ nanosheets highly active and stable in hydrogen evolution reaction.

Time is rapidly running out to make the crucial planning decisions and secure investment to keep the UK on track to deliver a reliable affordable and decarbonised energy system to meet future emissions regulation enshrined in the 2008 Climate Change Act according to a report published today by the Royal Academy of Engineering.

Prepared for the Prime Minister's Council for Science and Technology A critical time for UK energy policy details the actions needed now to create a secure and affordable low carbon energy system for 2030 and beyond.

The study looks at the future evolution of the UK’s energy system in the short to medium term. It considers how the system is expected to develop across a range of possible trajectories identified through modelling and scenarios.

The following actions for government are identified as a matter of urgency:

• enable local or regional whole-system large scale pilot projects to establish real-world examples of how the future system will work. These must move beyond  current single technology demonstrators and include all aspects of the energy systems along with consumer behaviour and financial mechanisms
• drive forward new capacity in the three main low carbon electricity generating technologies: nuclear carbon capture and storage (CCS) and offshore wind
• develop policies to accelerate demand reduction especially in domestic heating and introduce smarter demand management
• clarify and stabilise market mechanisms and incentives in order to give industry the confidence to invest.

New technologies could become unexpectedly significant – such as solar PV which has recently become much cheaper. But large scale deployment of novel technologies would take decades and the system cannot be planned on promises and aspirations alone. The Academy calls instead for a combination of known technologies to be scaled up to unprecedented levels and integrated in smarter ways.

The report notes that the addition of shale gas or tight oil is unlikely to have a major impact on the evolution of the UK's energy system as we already have secure and diverse supplies of hydrocarbons from multiple sources.

Dr David Clarke FREng who led the group that produced the report says: “Updating the UK energy system to meet the ‘trilemma’ of decarbonisation security and affordability is a massive undertaking. Meeting national targets affordably requires substantial decarbonisation of the electricity system by 2030 through a mix of nuclear power CCS and renewables with gas generation for balancing. Beyond 2030 we must then largely decarbonise heat and transport potentially through electrification but also using other options such as hydrogen and biofuels. We also need to adapt our transmission and distribution networks to become ‘smarter’”.

"Failure to plan the development of the whole energy system carefully will result at best in huge increases in the cost of delivery or at worst a failure to deliver. Substantial investment is needed and current investment capacity is fragile. For example in the last month projects like Carlton’s new Trafford CCGT plant have announced further financing delays and the hoped-for investment by Drax in the White Rose CCS demonstrator has been withdrawn. The UK has also dropped four places to 11th in EY’s renewable energy country attractiveness index.”

Link to document download on Royal Society Website