Applications & Pathways

The H2-ICE project aims at developing through numerical simulation a new generation of hybrid powertrains featuring a hydrogen-fueled Internal Combustion Engine (ICE) suitable for 12 m urban buses in order to provide a reliable and cost-effective solution for the abatement of both CO2 and criteria pollutant emissions. The full exploitation of the potential of such a traction system requires a substantial enhancement of the state of the art since several issues have to be addressed. In particular the choice of a more suitable fuel injection system and the control of the combustion process are extremely challenging. Firstly a high-fidelity 3D-CFD model will be exploited to analyze the in-cylinder H2 fuel injection through supersonic flows. Then after the optimization of the injection and combustion process a 1D model of the whole engine system will be built and calibrated allowing the identification of a “sweet spot” in the ultra-lean combustion region characterized by extremely low NOx emissions and at the same time high combustion efficiencies. Moreover to further enhance the engine efficiency well above 40% different Waste Heat Recovery (WHR) systems will be carefully scrutinized including both Organic Rankine Cycle (ORC)-based recovery units as well as electric turbo-compounding. A Selective Catalytic Reduction (SCR) aftertreatment system will be developed to further reduce NOx emissions to near-zero levels. Finally a dedicated torque-based control strategy for the ICE coupled with the Energy Management Systems (EMSs) of the hybrid powertrain both optimized by exploiting Vehicle-To-Everything (V2X) connection allows targeting H2 consumption of 0.1 kg/km. Technologies developed in the H2-ICE project will enhance the know-how necessary to design and build engines and aftertreatment systems for the efficient exploitation of H2 as a fuel as well as for their integration into hybrid powertrains.

The average temperature of the Earth has risen due to the accumulation of greenhouse gases emitted from the usage of fossil fuels. The consequential climate changes have caused various problems fueling the growing demand for environmentally friendly energy sources that can replace fossil fuels. Batteries and hydrogen have thus been utilized as substitute energy sources for automobiles to reduce fossil fuel consumption. Consequently the number of hydrogen refueling stations is increasing due to an increase in the number of hydrogen-powered vehicles. However several incidents have been reported in the United States of America and Japan where hydrogen refueling stations have been operating for a long time. A risk assessment of hydrogen refueling stations operating in urban areas was performed in this study by calculating the risk effect range using a process hazard analysis tool (PHAST) v8.7 from DNV-GL and a hydrogen risk assessment model (HyRAM) from Sandia National Laboratories (SNL). The societal risk was assessed through a probit model based on the calculation results. The assessment results showed that the risk caused by jet fire and overpressure in an incident is lower than the ‘as low as reasonably practicable’ (ALARP) level.

Facing global warming and recent bans on the use of diesel in vehicles there is a growing need to develop vehicles powered by renewable energy sources to mitigate greenhouse gas and pollutant emissions. Among the various forms of non-fossil energy for vehicles hydrogen fuel is emerging as a promising way to combat global warming. To date most studies on vehicle carbon emissions have focused on diesel and electric vehicles (EVs). Emission assessment methodologies are usually developed for fast-moving consumer goods (FMCG) which are non-durable household goods such as packaged foods beverages and toiletries instead of vehicle products. There is an increase in the number of articles addressing the product carbon footprint (PCF) of hydrogen fuel cell vehicles in the recent years while relatively little research focuses on both vehicle PCF and fuel cycle. Zero-emission vehicles initiative has also brought the importance of investigating the emission throughout the fuel cycle of hydrogen fuel cell and its environmental impact. To address these gaps this study uses the life-cycle assessment (LCA) process of GREET (greenhouse gases regulated emissions and energy use in transportation) to compare the PCF of an EV (Tesla Model 3) and a hydrogen fuel cell car (Toyota MIRAI). According to the GREET results the fuel cycle contributes significantly to the PCF of both vehicles. The findings also reveal the need for greater transparency in the disclosure of relevant information on the PCF methodology adopted by vehicle manufacturers to enable comparison of their vehicles’ emissions. Future work will include examining the best practices of PCF reporting for vehicles powered by renewable energy sources as well as examining the carbon footprints of hydrogen production technologies based on different methodologies.

This paper uses a whole-system approach to examine different strategies related to the future role of the gas grid in a low-carbon heat system. A novel model of integrated gas electricity and heat systems HEGIT is used to investigate four key sets of scenarios for the future of the gas grid using the UK as a case study: (a) complete electrification of heating; (b) conversion of the existing gas grid to deliver hydrogen; (c) a hybrid heat pump system; and (d) a greener gas grid. Our results indicate that although the infrastructure requirements the fuel or resource mix and the breakdown of costs vary significantly over the complete electrification to complete conversion of the gas grid to hydrogen spectrum the total system transition cost is relatively similar. This reduces the significance of total system cost as a guiding factor in policy decisions on the future of the gas grid. Furthermore we show that determining the roles of low-carbon gases and electrification for decarbonising heating is better guided by the trade-offs between short- and long-term energy security risks in the system as well as trade-offs between consumer investment in fuel switching and infrastructure requirements for decarbonising heating. Our analysis of these trade-offs indicates that although electrification of heating using heat pumps is not the cheapest option to decarbonise heat it has clear co-benefits as it reduces fuel security risks and dependency on carbon capture and storage infrastructure. Combining different strategies such as grid integration of heat pumps with increased thermal storage capacity and installing hybrid heat pumps with gas boilers on the consumer side are demonstrated to effectively moderate the infrastructure requirements consumer costs and reliability risks of widespread electrification. Further reducing demand on the electricity grid can be accomplished by complementary options at the system level such as partial carbon offsetting using negative emission technologies and partially converting the gas grid to hydrogen.

Hydrogen addition affects the composition of exhaust gases in vehicles. However the effects of hydrogen addition to compression ignition engines in running vehicles have not been evaluated. Hydrogen‑mixed air was introduced into the air intake of a truck equipped with a direct‑ injection diesel engine and running on a chassis dynamometer to investigate the effect of hydrogen addition on fuel consumption and exhaust gas components. The reduction in diesel consumption and the increase in hydrogen energy share (HES) showed almost linear dependence where the percentage decrease in diesel consumption is approximately 0.6 × HES. The percentage reduction of CO2 showed a one‑to‑one relationship to the reduction in diesel consumption. The reduction in emissions of CO PM and hydrocarbons (except for ethylene) had one to one or a larger correlation with the reduction of diesel consumption. On the other hand it was observed that NOx emissions increased and the percentage increase of NOx was 1.5~2.0 times that of HES. The requirement for total energy supply was more when hydrogen was added than for diesel alone. In the actual running mode only 50% of the energy of added hydrogen was used to power the truck. As no adjustments were made to the engine in this experiment a possible disadvantage that could be improved by adjusting the combustion conditions.

An integrated system is studied to supply green hydrogen feedstock for ammonia production in the Netherlands. The system is modeled to compare wind and solar resources when coupled to Alkaline Electrolysis (AEL) and Proton Exchange Membrane Electrolysis (PEMEL) technologies with a compressed hydrogen storage system. The nominal installed capacity of the electrolysis plant is around 2.3 GW with the most suitable energy source offshore wind and the preferred storage technology pressurized tubes. For Alkaline Electrolysis and Proton Exchange Membrane Electrolysis technologies the levelized cost of hydrogen is 5.30 V/kg H2 and 6.03 V/kg H2 respectively.

The intermittency of renewable energy technologies requires adequate storage technologies. Hydrogen systems consisting of electrolysers storage tanks and fuel cells can be implemented as well as batteries. The requirements of the hydrogen purification unit is missing from literature. We measured the same for a 4.5 kW PEM electrolyser to be 0.8 kW for 10 min. A simulation to hybridize the hydrogen system including its purification unit with lithium-ion batteries for energy storage is presented; the batteries also support the electrolyser. We simulated a scenario for operating a Dutch household off-electric-grid using solar and wind electricity to find the capacities and costs of the components of the system. Although the energy use of the purification unit is small it influences the operation of the system affecting the sizing of the components. The battery as a fast response efficient secondary storage system increases the ability of the electrolyser to start up.

Hydrogen due to its high energy density stands out as an energy storage method for the car industry in order to reduce the impact of the automotive sector on air pollution and global warming. The fuel cell electric vehicle (FCEV) emerges as a modification of the electric car by adding a proton exchange membrane fuel cell (PEMFC) to the battery pack and electric motor that is capable of converting hydrogen into electric energy. In order to control the energy flow of so many elements an optimal energy management system (EMS) is needed where rule-based strategies represent the smallest computational burden and are the most widely used in the industry. In this work a rulebased operation mode control strategy for the EMS of an FCEV validated by different driving cycles and several tests at the strategic points of the battery state of charge (SOC) is proposed. The results obtained in the new European driving cycle (NEDC) show the 12 kW battery variation of 2% and a hydrogen consumption of 1.2 kg/100 km compared to the variation of 1.42% and a consumption of 1.08 kg/100 km obtained in the worldwide harmonized light-duty test cycle (WLTC). Moreover battery tests have demonstrated the optimal performance of the proposed EMS strategy

The transportation sector is a significant source of greenhouse gas emissions. Electric vehicles (EVs) have gained popularity as a solution to reduce emissions but the high load of charging stations poses a challenge to the power grid. Nuclear-Renewable Hybrid Energy Systems (N-RHES) present a promising alternative to support fast charging stations reduce grid dependency and decrease emissions. However the intermittent problem of renewable energy sources (RESs) limits their application and the synergies among different technologies have not been fully exploited. This paper proposes a predictive and adaptive control strategy to optimize the energy management of N-RHES for fast charging stations considering the integration of nuclear photovoltaics and wind turbine energy with a hydrogen storage fuel cell system. The proposed dynamic model of a fast-charging station predicts electricity consumption behavior during charging processes generating probabilistic forecasting of electricity consumption time-series profiling. Key performance indicators and sensitivity analyses illustrate the practicability of the suggested system which offers a comprehensive solution to provide reliable sustainable and low-emission energy to fast-charging stations while reducing emissions and dependency on the power grid.

This article proposes a supply chain-based green hydrogen microgrid modelling for a number of remote Australian communities. Green hydrogen can be used as an emissions-free fuel source for electricity generation in places where large-scale renewable energy production is impossible due to land availability population or government regulations. This research focuses on the Torres Strait Island communities in northern Australia where the transition from diesel to renewable electricity generation is difficult due to very limited land availability on most islands. Due to geographical constraints low population and smaller electrical load the green hydrogen needs to be sourced from somewhere else. This research presents a green hydrogen supply chain model that leverages the land availability of one island to produce hydrogen to supply other island communities. In addition this research presents a model of producing and transporting green hydrogen while supplying cheaper electricity to the communities at focus. The study has used a transitional scenario planning approach and the HOMER simulation platform to find the least-cost solution. Based on the results a levelised cost of energy range of AU$0.42 and AU$0.44 was found. With the help of a green hydrogen supply chain CO2 emissions at the selected sites could be cut by 90 %. This study can be used as a guide for small clustered communities that could not support or justify large-scale renewable generation facilities but need more opportunities to install renewable generation.